TY - JOUR
T1 - High-Throughput Fabrication of Nanocomplexes Using 3D-Printed Micromixers
AU - Bohr, Adam
AU - Boetker, Johan
AU - Wang, Yingya
AU - Jensen, Henrik
AU - Rantanen, Jukka
AU - Beck-Broichsitter, Moritz
N1 - Copyright © 2016 American Pharmacists Association®. Published by Elsevier Inc. All rights reserved.
PY - 2017
Y1 - 2017
N2 - 3D printing allows a rapid and inexpensive manufacturing of custom made and prototype devices. Micromixers are used for rapid and controlled production of nanoparticles intended for therapeutic delivery. In this study, we demonstrate the fabrication of micromixers using computational design and 3D printing, which enable a continuous and industrial scale production of nanocomplexes formed by electrostatic complexation, using the polymers poly(diallyldimethylammonium chloride) and poly(sodium 4-styrenesulfonate). Several parameters including polymer concentration, flow rate, and flow ratio were systematically varied and their effect on the properties of nanocomplexes was studied and compared with nanocomplexes prepared by bulk mixing. Particles fabricated using this cost effective device were equally small and homogenous but more consistent and controllable in size compared with those prepared manually via bulk mixing. Moreover, each micromixer could process more than 2 liters per hour with unaffected performance and the setup could easily be scaled-up by aligning several micromixers in parallel. This demonstrates that 3D printing can be used to prepare disposable high-throughput micromixers for production of therapeutic nanoparticles.
AB - 3D printing allows a rapid and inexpensive manufacturing of custom made and prototype devices. Micromixers are used for rapid and controlled production of nanoparticles intended for therapeutic delivery. In this study, we demonstrate the fabrication of micromixers using computational design and 3D printing, which enable a continuous and industrial scale production of nanocomplexes formed by electrostatic complexation, using the polymers poly(diallyldimethylammonium chloride) and poly(sodium 4-styrenesulfonate). Several parameters including polymer concentration, flow rate, and flow ratio were systematically varied and their effect on the properties of nanocomplexes was studied and compared with nanocomplexes prepared by bulk mixing. Particles fabricated using this cost effective device were equally small and homogenous but more consistent and controllable in size compared with those prepared manually via bulk mixing. Moreover, each micromixer could process more than 2 liters per hour with unaffected performance and the setup could easily be scaled-up by aligning several micromixers in parallel. This demonstrates that 3D printing can be used to prepare disposable high-throughput micromixers for production of therapeutic nanoparticles.
U2 - 10.1016/j.xphs.2016.10.027
DO - 10.1016/j.xphs.2016.10.027
M3 - Journal article
C2 - 27938892
VL - 106
SP - 835
EP - 842
JO - Journal of Pharmaceutical Sciences
JF - Journal of Pharmaceutical Sciences
SN - 0022-3549
IS - 3
ER -